So I took the hard drive out and launched into Fedora with no HDD in. I rebooted and I was unable to load into the live distro again - getting stuck at the bootloader waterfall.Īfter reading this post I thought maybe I messed up the partition table on the hard drive and it's somehow screwing with all the distros (nvme SSD connected to an M.2 slot.) Manjaro loaded into the live distro the first time but when I attempted to install it hung on "78% configuring hardware". I had to run apt install firmware-amd-graphics to get graphics working but all seemed well from there. I installed Debian successfully but had broken graphics. Tried nomodeset=0 in the launch options (I think that's the same as safe graphics mode?) I have since tried a different a few things with no success: Let us know your problems with Linux Fedora and Hyper-v.NVME SSD via M.2 unknown brand (Toshiba I think) That’s all you have to do for installing Linux Fedora on Hyper-v Windows 10. Chose all the exact you want then finalize the initial configuration and start using Fedora as the guest machine on Hyper-v beside your Windows 10. Go ahead and reboot to start using it.Ĩ. The final configurations are selecting keyboard, language, timezone and location. Finally when Fedora successfully installed and ready for you to use. Don’t do anything, let the system will install software, installing boot loader and everything that your system need. Note: When you creating users for Linux Fedora, check the tick’s of Make this user administrator to join the user to admins group. On the User Settings page, set a root password and create a user for yourself. When everything has been configured, click Begin Installation. But when you installing on a physical hard disk, make sure of losing files.Ħ. I’m installing on Hyper-v virtual machine and I do not care about losing files from hard disk. Select the timezone, network interface, and hard disk partition. Select the exact language you want to have on Linux Fedora and click Continue. Otherwise chose the Install to Hard Drive and continue the installation process.Ĥ. If you want to test the Fedora before installation, select Try Fedora. Select Start Fedora Live and press enter to boot with Fedora live workstation. When you have created a virtual machine, open and run with Linux Fedora Image.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |